Technical Information
| Dimensions | 37½"L x 6"W x 2"H |
| Weight | 14lb without mounting bracket |
| Power Connection Wire allocation in the supply cable |
Supplied with 5ft of 4 Core + GND 'pigtail' cable Conductor #1 – Hot for heating Circuit A Conductor #2 – Hot for heating Circuit B Conductor #3 – Neutral for heating Circuit A Conductor #4 – Neutral for heating Circuit B |
| Mounting | Wall / Ceiling Mount Brackets / Under Beam Side Beam / Ceiling Recessed / Mount Brackets |
| Application | Indoor and Outdoor Use |
| USA / Canada | Total input power: 1200 Watts Input power per stage: 600 Watts Working Voltage: 120 Volt / 1Ph / 60Hz Total current load: 10 Amp Current per heating stage: 5 Amp |
| NOTES: | Non glowing heating panels can be indirectly connected to 208V/120V 3-Phase / 4-wire / WYE / or 240 Volt Split-Phase with Mid-Point Neutral Power system when properly interfaced via HeatRay's POWER CONTROL MODULES.
Please refer to the TECHNOLOGY tab & ELECTRICAL DIAGRAM section of our website for further details |
 |
Non glowing panels are IP X5 (NEMA 4) rated, which means they are protected against unforeseen exposure to rain or water jets. This enables the heaters to be installed outdoors and safely washed and rinsed with low pressure water cleaners and garden hoses. |
 |
Two-stage HIGH - LOW heat output allows the provision of an optimum heat comfort when experiencing varying ambient cold conditions. This arrangement brings additional benefit of lowering the overall power consumption, thus the running costs, when higher heating power is not needed. |
 |
Each heating panel covers 15 sq ft - 30 sq ft of floor space depending on the installation height and final application. |
 |
The HeatRay Non glowing heating system aims soft energy in a specific direction to warm people and objects in its path, instead of wasting energy trying to heat unoccupied spaces. |
 |
Why run heaters in areas that are not in use, operate multiple groups of heaters independently of each other (up to 4, 8 or 12 heaters per heating zone) with dedicated Heatray control modules. |
 |
HeatRay Non Glowing Radiant Panel Heaters have undergone extensive independent laboratory testing to establish full compliance to the UL & CSA Listing in US & Canada as well as European CE marking and Australian & New Zealand AS /NZ Certification. Above approvals incorporate Compliance with Outdoor Usage, as well as Design Integrity, Product Application and Heat Effect on Structures. 
|
